Blade design: The blade is straight (without any spiral or wavy pattern), with a sharp side edge, and may have a flat base or a slight chamfer at the bottom.
Material: Commonly used materials include hard alloy (tungsten steel), high-speed steel (HSS), or coated blades, which are highly hard and wear-resistant.
Specification parameters:
Diameter: 1mm~20mm (commonly seen are 6mm, 8mm, 10mm, etc.).
Blade length: short blade (for shallow grooves) or long blade (for deep groove machining).
Shank diameter: 6mm, 8mm, etc., needs to match with the collet.
