Trace a Finish Line Across an NG-Routed Veneered Rail

An NG-routed veneered rail can look continuous just after routing, then show a faint straight line through the finished profile. When that line crosses a rounded feature, its visibility changes with the viewing angle. Establish where it originates before changing the cutting setup. A joint under the veneer and a mark following the routed contour call for different investigations.

NG-routed veneered rail with a faint straight finish line across the routed profile, shown before and after finishing
NG-routed veneered rail with a faint straight finish line across the routed profile, shown before and after finishing

CNCBit describes the NG as a multi-shape cutter for ornamental furniture edges and molding. The manufacturer advises comparing the complete profile with the drawing and using a trial pass. For an NG-routed veneered rail, include a trial section that crosses the same substrate construction as the production piece. On the back of the sample, mark the location of any known substrate joint before routing. Carry the mark onto a sketch of the specimen so its position remains available after the finish covers the face.

Take a reference image immediately after routing, with the light running across the NG-routed veneered rail. Repeat the photograph after the approved finish sequence, from the same position. Note whether the new line follows a fixed station across several different features or follows a single ridge along the piece. At the ends of the specimen, use the back marks to locate the substrate joint on the sketch. A line that coincides with that station is reason to examine the panel construction. The coincidence alone cannot establish whether a joint has moved or whether its outline has become more visible because of the finish.

Where another specimen is available, compare an otherwise similar section of the same trial stock away from the joint. Keep its profile, finish sequence and viewing conditions comparable. Record where the observation was made and when it first became visible. Preserve the samples with the photographs so the finish reviewer can examine the rounded feature under the agreed viewing conditions. Substrate preparation and permissible show-through belong in the project finish and construction documents.

Similar Posts